Description
Anode assembly is also referred to as anode hanger, it is assembled by welding with aluminium stem (rod) and steel bracket (yoke) with transition joint insert(also refered to as a clad) in between.
Anode assemblies are subject to high terminal and mechanical loads, it is therefore of utmost importance that all welds, particulartly the aluminium –aluminium welds are carried out with extreme care.



Quality Control
All welding will be performed in indoor workshop. Alignment, jigging and welding sequence will be carefully prepared to minimize distortion and residual stress. All butt welds are full penetration welds.
Color changing paint/thermocouple/temperature test pen are used to strictly control the aximum temperature under 350℃ at the interface to avoid the formation of brittle intermetallic compounds that could reduce the clad quality.
The welds complies with Class C in standard EN 10042 for the aluminium part and Class C in standard EN 5817 for the steel parts.

Features
Excellent Conductivity
Top Welding Quality
100% NDE Tested
Safe and Reliable
Products Exported to Europe

Technical Parameters

Material	Al Rod	Clad	Steel Yoke
	10501060 107040436063	Al 1050/1060 Steel Q235B or per Buyer’s Requirement	Low Carbon Steel
Process	Welding (Al-Al welding between Al Rod and Clad Fe-Fe Welding between Clad and Steel Yoke)
NDE Test	UT MT PT
Temperature Control	Color-Changing Paint and Thermalcouple
Packing	Wooden Case aluminium rod packed with air-bubble film
Shipment	By Container