Aluminum discs are widely used in electronics, daily chemicals, medicine, culture and education, auto parts and other industries. Electrical, thermal insulation, machinery manufacturing, automotive, aerospace, mold, construction, printing and other industries. Non-stick pans, pressure cookers and other kitchen utensils, as well as lampshades, water heater shells, wire drawing cabinets and other hardware products, are one of the deep-processing products of aluminum alloy strips with a large amount of consumption.

Aluminum discs automatic assembly line processing



The main components of the aluminum discs uncoiler blanking production line are: feeding car, uncoiler, flattener, feeder, swing unit, special closed single-point press, quick die change device, stacking unit, scrap shears cutting, hydraulic system, electronic control system, etc.

Features of aluminum discs production line:

The first is fully automatic numerical control. This aluminum discs production line starts from the coil material until the whole coil material is completely blanked. There is no need to manually contact any material in the middle, and no manual adjustment is required, which fundamentally eliminates the production safety hidden danger of ordinary punching. and product quality hazards.

The aluminum discs production line can directly use the coil to make the round sheet, without the need for slitting and cross-cutting the coil, which reduces the production process, reduces the production cost, and reduces the possibility of damage to the surface of the coil. The sheet is guaranteed to be free from oil stains and scratches.

The aluminum discs production line makes full use of the width of the coil and is controlled by a high-precision servo motor drive system, which reduces the coil spacing and the distance from the coil to the edge of the material to a minimum, fundamentally reduces the amount of waste, and the utilization rate of raw materials reaches 80% above.

The production speed can reach 40-55 pieces per minute, which improves the production efficiency.

Changeover time can be reduced to less than 15 minutes when converting the production specifications of aluminium discs due to the modular mould design. Discs with diameters from 80 mm to 700 mm can be produced.

The second is the production process of aluminum discs with a diameter greater than 700mm
1. Blank cutting (cut into squares)
2. Blanking (blanking into required aluminum discs)